Payment & Shipping Terms:
|Pump::||CNP NM FIRE||Casing：:||Ductile Cast Iron|
horizontal end suction centrifugal pumps,
single stage fire pump
Water Use UL Listed Centrifugal End Suction Fire Pumps 300GPM @ 125PSI FM Approved
The appeal of an end suction pump is usually its lower initial cost. If the pump can perform at a given rating and pressure, then this type of pump is adequate. If diesel-engine driven, another advantage is the ability to have an engine parallel and close to a wall (assuming proper air venting is considered). This can save space in a mechanical room piping layout.
The removal of the impeller requires pulling the impeller back out of the casing, which requires removal of the motor to provide space for this to happen. Often this is a more difficult procedure for those maintaining the pump.
|HEAD||PUMP MODEL||SPEED||MAX SHAFT POWER|
NFPA20, UL, FM, EN12845,CCCF
How it Works:
The end suction centrifugal pump normally contains a single impeller and a spiral like casing. The fluid that is being pumped moves along the impeller’s vanes, which increases the fluid’s velocity. From there the fluid is moved into the spiral like casing, where the high velocity is transformed into high pressure by a diffusion process.
End Suction Fire Pump
NM Fire is the firt member of NFPA from Chinese pump manufacturers. The production of fire pump groups is strictly in accordance with NFPA20, production process and performance testing also meet the requirement of ISO9001, some kinds of products have got APSAD (France), UL,FM and CCCF certificates.
We are the only enterprise in China that obtained not only UL and FM certificates, but CCCF as well, also the firt company in the world who was authorized by UL CCIC as witness testing center for both fire pump and fire fighting engines.
Contact Person: Kathy Wong